FMK30 Concentrate

Concentrate FMK30 - RDF 50 - RDF 62 

Preparation:

For best results, use the following tools:

· FMK 30 Concentrate

· Window cleaner spray bottle

· Spray bottle

· FVR 10 squeegee

· Kitchen roll

· Cutter

· Window squeegee

Application:

Preliminary cleaning:

• Start by thoroughly cleaning the window using a window squeegee, window cleaner spray or even a scraper if necessary.
• Dry your window thoroughly with kitchen paper.

Pre-cut the film:

• Simply pre-cut the film on a table using a cutter, to a size 2 to 3 cm larger than the window.
• Remove the protective film
• Peel off the protective film from the adhesive side and thoroughly wet the adhesive side of the film with FMK 30 concentrate (diluted in 0.5 litres of water).
• Spray the diluted FMK 30 concentrate generously onto the glass.

Apply the adhesive to the glass:

• Apply the adhesive side of the film to the glass (inside).

 Smooth with the FVR10 squeegee:

•   Spray the diluted FMK 30 concentrate onto the film again and smooth with the FVR 10 squeegee (to remove air bubbles). Work from the centre outwards, starting at the top. If joining two pieces of film, apply them edge to edge.

 Finishing touches:

• • Remove excess water with paper towels, taking care not to move the film.
  • Finally, trim the film to a size 2 mm smaller than the window (the film must not touch the frame) and smooth again.